Rwraps Engine Turn Vinyl Sheet Roll in Black - 24" x 24" - Non Porous Surface Adhesive Backed Simple Curve Wrap Film, Vehicle Decorative Application, Bubble Free Car Sticker

Rwrap simple curve film is designed to allow you to customize any hard, flat and non-porous surface. The film is a polyester based high gloss adhesive backed film that allows for semi-permanent application. It is not intended for moderate to extreme curved applications such as our R DuraWrap series films. How to apply Rwrap Light Film: Measure the application area where the film is going to be applied. Take into consideration any bends or compound curves that may need the material to bend when wrapping. Choose the most applicable size. A Tailor's Tape works well when measuring. With the properly sized film selected, simply mist the film and application area with the recommended application solution, apply it over the area, heat the film with a hair dryer, apply it to the surface with a squeegee or other hard card and trim away the excess. If it sounds hard, don't worry we provide online instructional videos. Recommended application Tools? We recommends the use of an application squeegee which will reduce air bubbles during installation and aide in heat conforming the film to your application area. By using a low friction sleeve, you will reduce the chance of scratching your film during application. Application solutions such as Rapid Clear will remove any dirt or debris from your application surface and Rapid Tac will aide in the wet application of our adhesive backed film kits. Rwrap Film vs. R DuraWrap film: R DuraWrap film is generally made from a 6mil (.008"") thick film. Rwrap Film is made from a vinyl which is 3mil (.003"") thick and designed to apply to relatively flat surfaces.